NPort 5450I-T
0 products currently in stock. Call our team for lead times if needed.
£783.00
NPort 5450I-T
£783.00
4-port device server, 10/100M ethernet, RS-232/422/485 DB9 male, w/ 2 kV isolation, 12~48 VDC, -40~75℃, w/ adapter
Introduction
NPort® 5400 device servers provide many useful features for serial-to-Ethernet applications, including an independent operation mode for each serial port, user-friendly LCD panel for easy installation, dual DC power inputs, and adjustable termination and pull high/low resistors.
Network Readiness for up to 4 Serial Devices
NPort® 5400 device servers can conveniently and transparently connect up to four serial devices to an Ethernet network, allowing you to network your existing serial devices with only basic configuration. Data transmission between the serial and Ethernet interfaces is bidirectional. By using NPort® device servers, you not only protect your current hardware investment, but also allow for future network expansion. You can both centralize the management of your serial devices and distribute management hosts over the network.
Independent Operation Mode for Each Serial Port
NPort® 5400 device servers can be used to connect different devices for remote data polling or event handling over a TCP/IP network. Each serial port on the NPort® 5400 operates independently to provide maximum versatility. For example, port 1 can operate in Driver mode, port 2 in TCP Server mode, and ports 3 and 4 in TCP Client mode.
User-friendly LCD Panel for Easy Installation
An LCD panel is built into the NPort® 5400’s top panel, with four buttons for data input, configuration, and operation mode selection. The LCD panel displays the server name, serial number, and IP address, and it can be used to enter or modify parameters such as IP address, netmask, and gateway. (The LCD panel is not available on wide-temperature models.)
Dual DC Power Inputs
NPort® 5400 device servers support dual power sources by providing both a DC terminal block input and a DC power jack input. Providing two types of power inputs gives users greater flexibility for use with different applications.
Adjustable Termination and Pull High/Low Resistors
The NPort 5400 Series provides adjustable termination and pull high/low resistors for RS-485 applications. In some critical environments, termination resistors may be needed to prevent the reflection of serial signals, and the pull high/low resistors may need adjusting to maintain the integrity of the electrical signal. Since no set of resistor values is universally compatible with all environments, the NPort® 5400 has four sets of DIP switches on the bottom panel to set the termination and pull high/low resistor values.
Additional information
Configuration Options | |
---|---|
Management | |
Filter | |
Authentication | |
Encryption | |
Connector | |
RS-232 | |
RS-422 | |
RS-485-4w | |
Input Current | |
No. of Power Inputs | |
Power Connector | |
Automatic Reboot Trigger | |
Isolation | |
Terminator for RS-485 | |
Housing | |
Dimensions (with ears) | |
Dimensions (without ears) | |
Installation | Desktop, DIN-rail mounting (with optional kit), Wall mounting |
EMC | |
Time | |
Standards | |
Warranty Period | |
Details | |
Alert Tools | |
Operating Temperature | -40 to 75°C (-40 to 167°F) |
Need Support?
We understand that it can be difficult to find the right products for your needs. That’s why our dedicated customer support team is available to assist you in any way possible. Whether you need help selecting the best product for your application or more information on a particular device, our knowledgeable staff is here to provide you with the answers you need. Contact us today for more information about how we can help you get the products and support you need!
Product Brand
NPort 5400 Series
4-port device server, 10/100M ethernet, RS-232 DB9 male, 12~48 VDC, 0~55°C, w/o adapter
£438.00
5 in stock (can be backordered)
4-port device server, 10/100M ethernet, RS-232/422/485 DB9 male, w/ 2 kV isolation, 12~48 VDC, 0~55℃
£747.00
4-port device server, 10/100M ethernet, RS-232/422/485 DB9 male, RS-232/422/485 12~48 VDC, 0~55°C
£525.00
5 in stock (can be backordered)
4-port device server, 10/100M ethernet, RS-232/422/485 DB9 male, 12~48 VDC, -40~ 75℃, w/ adapter
£600.00
4-port device server, 10/100M ethernet, RS-422/485 terminal block, w/ 2 kV isolation, 12~48 VDC, 0~55°C
£664.00
10 in stock (can be backordered)
4-port device server, 10/100M ethernet, RS-422/485 terminal block, 12~48 VDC, 0~55°C
£501.00
24 inch fanless panel computer with Intel Core i7 processor 2610UE 1.50GHz CPU, NMEA 0183, SSD trays, dual AC/DC power inputs, tap bonding
£5,624.00
7 inches industrial panel computer, E3826 CPU, 4GB RAM, 32GB CFast, W7E OS, 1000 nits, 16:9 aspect ratio, IP66 in front, touch
£2,202.00
Arm-based DIN-rail wireless-enabled industrial computer with wide operating temperature, 4 serial ports, 2 LANs, 4 DI/DOs, and MOXA Industrial Linux pre-installed
£864.00
Available on back-order
4 data line advanced level surge protector for RS422/485, -40 to 85°C, 5V clamping voltage
£175.00
Small Form Factor pluggable transceiver with 100Base single-mode, LC connector, 80Km, -40 to 85°C
£827.00
WiFi module (11n 2T2R + 11ac 3T3R) RJ45 Ethernet interface (delivered without antenna nor pigtail cable)
8 GbE + 2 GbE industrial secure router with Firewall/NAT/VPN, 120/220 VDC/VAC , -40 to 75°C
£2,468.00
Available on back-order
Industrial Unmanaged Ethernet Switch with 14 10/100BaseT(X) ports, 2 multi mode 100BaseFX ports, SC connector, -10 to 60°C
£629.00
Available on back-order
Software, Firmware, and Drivers
NAME | TYPE | CHECKSUM | VERSION | OPERATING SYSTEM | RELEASE DATE |
---|---|---|---|---|---|
2.0 MB |
Utility |
SHA-512
|
v1.3 |
|
Jun 29, 2023Release notes |
11.6 MB |
Utility |
SHA-512
|
v1.3 |
|
Jun 29, 2023Release notes |
2.2 MB |
Utility |
SHA-512
|
v2.7 |
|
Jun 28, 2023Release notes |
123.0 KB |
Driver |
SHA-512
|
v6.0 |
|
May 04, 2023Release notes |
32.8 MB |
Software Package |
SHA-512
|
v1.4 |
|
May 02, 2023Release notes |
277.4 MB |
Software Package |
SHA-512
|
v1.1.0 |
|
Feb 08, 2023Release notes |
5.4 MB |
Driver |
SHA-512
|
v4.1 |
|
Feb 01, 2023Release notes |
7.7 MB |
Driver |
SHA-512
|
v4.0 |
|
Jan 17, 2023Release notes |
114.9 KB |
Driver |
SHA-512
|
v4.2 |
|
Jan 17, 2023Release notes |
NPort Administrator Suite v3.2 (Windows 7 to 8.1 and Windows Server 2008 R2 to 2016, WHQL certified)
4.1 MB |
Driver |
SHA-512
|
v3.2 |
|
Jan 17, 2023Release notes |
113.0 KB |
Driver |
SHA-512
|
v5.2 |
|
Jan 17, 2023Release notes |
18.0 MB |
Library |
SHA-512
|
v1.1 |
|
Dec 22, 2022Release notes |
6.8 MB |
Driver |
SHA-512
|
v3.5 |
|
Dec 01, 2022Release notes |
417.7 MB |
Software Package |
SHA-512
|
v3.2.8 |
|
Oct 31, 2022Release notes |
611.6 KB |
Driver |
SHA-512
|
v1.1 |
|
Sep 26, 2022Release notes |
2.2 MB |
Software Package |
SHA-512
|
v1.1 |
|
Mar 31, 2021Release notes |
24.3 MB |
Software Package |
SHA-512
|
v1.1 |
|
Mar 31, 2021Release notes |
850.2 KB |
Firmware |
SHA-512
|
v3.14 |
|
Mar 31, 2021Release notes |
92.2 KB |
Driver |
SHA-512
|
v2.0 |
|
Oct 24, 2019Release notes |
95.0 KB |
Driver |
SHA-512
|
v3.0 |
|
Oct 24, 2019Release notes |
2.6 MB |
Driver |
SHA-512
|
v2.0 |
|
Aug 01, 2019Release notes |
4.1 MB |
Driver |
SHA-512
|
v2.0 |
|
Feb 11, 2019Release notes |
230.5 KB |
Driver |
SHA-512
|
v1.6 |
|
Nov 14, 2012Release notes |
1.6 MB |
Utility |
SHA-512
|
v1.6 |
|
May 13, 2012Release notes |
1.2 MB |
Driver |
SHA-512
|
v1.14 |
|
Apr 04, 2012Release notes |
73.0 KB |
Driver |
SHA-512
|
v3.5 |
|
Mar 19, 2012Release notes |
484.3 KB |
Firmware |
SHA-512
|
v2.9 |
|
Sep 13, 2011Release notes |
Support Documents
NAME | TYPE | VERSION | RELEASE DATE |
---|---|---|---|
2.7 MB |
Datasheet | v2.1 | Jul 07, 2023 |
20.0 MB |
Manual | v7.0 | Jun 13, 2023 |
394.5 KB |
Tech Note | v2.0 | Jun 08, 2023 |
479.5 KB |
Tech Note | v2.0 | Jun 08, 2023 |
372.3 KB |
Tech Note | v2.0 | Jun 08, 2023 |
364.5 KB |
Tech Note | v2.0 | Jun 08, 2023 |
544.0 KB |
Tech Note | v2.0 | Jun 08, 2023 |
397.2 KB |
Tech Note | v2.0 | Jun 08, 2023 |
395.0 KB |
Tech Note | v2.0 | Jun 08, 2023 |
497.2 KB |
Tech Note | v2.0 | Jun 08, 2023 |
379.2 KB |
Tech Note | v2.0 | Jun 08, 2023 |
389.7 KB |
Tech Note | v2.0 | Jun 08, 2023 |
429.4 KB |
Tech Note | v2.0 | Jun 08, 2023 |
1.7 MB |
Tech Note | v2.1 | May 30, 2023 |
100.3 KB |
Tech Note | v1.0 | May 18, 2023 |
1.0 MB |
Manual | v2.1 | Mar 28, 2023 |
372.3 KB |
Tech Note | v1.0 | Aug 05, 2021 |
724.0 KB |
QIG | v7.3 | Apr 27, 2021 |
423.5 KB |
Tech Note | v1.1 | Apr 30, 2020 |
1.9 MB |
Tech Note | v1.0 | Nov 17, 2014 |
311.3 KB |
Tech Note | v1.0 | Jun 29, 2013 |
1.0 MB |
Tech Note | v1.0 | Mar 29, 2012 |
482.6 KB |
Tech Note | v1.0 | Nov 03, 2009 |
173.2 KB |
Tech Note | v1.0 | Nov 03, 2009 |
253.0 KB |
Tech Note | v1.0 | Nov 03, 2009 |
116.6 KB |
Tech Note | v1.0 | Nov 03, 2009 |
211.4 KB |
Tech Note | v1.0 | Nov 03, 2009 |
204.6 KB |
Tech Note | v1.0 | Nov 03, 2009 |
224.4 KB |
Tech Note | v1.0 | Nov 03, 2009 |
204.2 KB |
Tech Note | v1.0 | May 21, 2009 |
207.6 KB |
Tech Note | v1.0 | May 21, 2009 |
236.6 KB |
2D CAD | Aug 03, 1995 | |
236.6 KB |
2D CAD | Aug 03, 1995 | |
219.2 KB |
2D CAD | Aug 03, 1995 | |
233.5 KB |
2D CAD | Aug 03, 1995 | |
233.5 KB |
2D CAD | Aug 03, 1995 |